매립형 완전 용접 볼 밸브

Operating Precautions of Buried welded ball valve

1. Remove the protective cover at both ends and check whether the valve hole is faulty and clean. If there is foreign matter clean it up to avoid foreign matter between the groove and the ball to damage the sealing surface of the valve seat.

2. Try to open and close the ball valve several times to confirm whether the ball valve can work properly.

3. Between installing the ball valve to the pipeline, the welded surface of the pipe should be wiped clean. When installing the ball valve, it is not necessary to pay special attention to the installation direction of the ball valve.

4. Open the ball valve to be welded to avoid welding slag entering the valve during the welding process.

5. When installing horizontally, the valve must be fully open to avoid welding sparks from injuring the ball surface. When installed on a vertical guestway, the valve must be safely open if welding the upper interface; if welding the lower interface, the valve must be completely closed to avoid high heat burns inside the valve.

6. After welding is completed, wait for the valve to cool completely before operating the valve on and off.

7. When installing the turbo vortex actuator (valve size DN200 and above or special customization), first adjust the actuator switching position according to the valve switching position with reference to the arrow indication direction (shut off, open on), so that the arrow indication switching direction of the actuator is consistent with the valve switching position. Dock the actuator with the standard flange of the valve body correctly and adjust the position of the limit bolt appropriately so that the valve can be completely closed and opened, which can refer to the arrow indicating direction.